This blog post shows you how to test the filament current supply on an 11-065 when it is connected to the 04-303 ion source.
Make sure that the 11-065 main power switch is OFF and then remove all cables and the power cord. Put the 11-065 on the table top or bench. Note that you will need to connect the black high voltage cable from J9 on the back of the 11-065 to the 04-303 ion source.
Remove the top cover on the 11-065.
Remove the High Voltage cover on the right hand side. Remove the 4 outside screws, not the 4 inside screws.
The two high voltage boards are now visible.
On the right hand HV1 board, E93 is the high voltage output, E92 and E91 are the filament current output connectors. With the 11-065 power OFF and the high voltage OFF and set to zero, unplug the E92 connector and then connect a current meter that can go up to 10 amps DC between the E92 cable lug and the E92 connector on the HV1 board. Make sure that the meter leads are not touching anything.
CAUTION! High voltages can be present on this board. As long as you have the high voltage on the 11-065 set to zero (fully CCW) and the high voltage switch set to off, then there is no high voltage present. Refer this test to someone who is trained to work safety with high voltage if you are not familiar with operating a DVM.
Make sure that the beam voltage switch is set to zero and the beam voltage control potentiometer is turned fully CCW.
Connect the black high voltage cable between the 11-065 and the 04-303 ion source. Connect the main power cable to the back of the 11-065.
Make sure that the Emission adjust potentiometer is fully CCW and that the emission scale switch is in the X1 position,and then turn on the 11-065 main power. The emission current should be zero.
Slowly turn up the emission current (turn CW) until you get 25 mA of emission current.
The DC current meter should read approximately 2.7 amps DC current at 25 mA of emission current on the 11-065 emission meter.
If your emission current shoots up to 50mA when the 11-065 is first turned on or when the emission current is turned up then there is a problem with the 11-065 filament current circuit or the emission feedback circuit.
If you do not get any filament current then there is a problem with the 11-065 filament circuit or the ionizer in the 11-065.
For help with repairing your 11-065 controller please contact RBD Instruments for assistance.