11-065 28 Volt supply Check

Print Friendly, PDF & Email

The 28 V DC power supply in the PHI 11-065 ion gun control can become weak and cause symptoms such as low emission current. To test the supply, measure the voltage from the red wire to chassis ground. It should be 28 volts to 29 volts DC, with less than 100mV AC ripple. When defective, the DC voltage will be low (about 10 to 16 volts) and there will be high AC ripple (3 to 6 volts).

Measure from the red wire post to the chassis.  CAUTION – refer servicing and testing to qualified personnel.

28-volt-supply-test-point

28-volt-supply-test-point

 

 

If your 11-065 28 volt supply is defective, RBD carries them in stock at all times. Contact us for more information.

Leave a Reply

Your email address will not be published. Required fields are marked *